C.F.R. homeSearch C.F.R.
C.F.R.Title 15Part 10—Procedures for the Development of Voluntary Product Standards

15 C.F.R. § 10.8 (2026)

Standing Committee

Edition and currency
eCFR text as of Sept. 29, 2026. The text is the edition Syfert holds; for a past event, check the version in force on that date.
Other sources
CURRENTeCFR text as of Sept. 29, 2026

(a) The Department shall establish and appoint the members of a Standing Committee prior to the publication of a standard. The committee may include members from the Standard Review Committee, and shall consist of qualified representatives of producers, distributors, and users or consumers of the product covered by the standard, and representatives of appropriate general interest groups such as municipal, State, and Federal agencies. When requested by the Standing Committee, the Department shall appoint one voting member from among the representatives of the Federal agencies, other than the Department of Commerce. When requested by the Standing Committee for PS 20-70, “American Softwood Lumber Standard,” the Department shall appoint two voting members from among the representatives of the Federal agencies, other than the Department of Commerce. All other representatives of Federal agencies shall be advisory nonvoting members of Standing Committees. (Alternates to committee members may be designated by the Department.) When deemed appropriate by the Department, project funds under § 10.2, may be made available to assure participation by consumer interests on the committee at required meetings.

(b) Appointments to a Standing Committee may not exceed a term of 5 years. However, the committee may be reconstituted by the Department whenever appropriate, and members may be reappointed by the Department to succeeding terms. Appointments to the committee will be terminated upon the withdrawal of the standard.

(c) The Department shall be responsible for the organization of the committee. Any formal operating procedures developed by the committee shall be subject to approval by the Department. The committee may conduct business either in a meeting or through correspondence, but only if a quorum participates. A quorum shall consist of two-thirds of all voting members of the committee. A majority of the voting members of the committee participating shall be required to approve any actions taken by the committee except for the approval of revisions of the standard which shall be governed by the provisions of § 10.5 (b), (c), and (d),

(d) The members of a Standing Committee should be knowledgeable about:

(1) The product or products covered by the standard;

(2) The standard itself; and

(3) Industry and trade practices relating to the standard.

(e) The committee shall:

(1) Keep itself informed of any advancing technology that might affect the standard;

(2) Provide the Department with interpretations of provisions of the standard upon request;

(3) Make recommendations to the Department concerning the desirability or necessity of revising or amending the standard;

(4) Receive and consider proposals to revise or amend the standard; and

(5) Recommend to the Department the revision or amendment of a standard.

Enactment and amendments

Syfert holds no separate history line for this section. Where this code prints a source or history note, it appears with the text, usually at the end.

Versions

Edition shown: eCFR text as of Sept. 29, 2026. Syfert holds no earlier or later version of this section.

C.F.R. Home  |  Search C.F.R.  |  Search cases for this section  |  syfert.com