Already have an account? Sign in instead.
You stay signed in for 30 days on this browser.
Continue with Google Continue with MicrosoftNo account yet? Create a free one.
We sent a six-digit code.
It expires in ten minutes, works once, and only in this browser. Five wrong tries void it. Send another code.
Your account is live and the Cloudflare checks are off for this browser.
Technical requirements for ground penetrating radars and wall imaging systems
(a) The UWB bandwidth of an imaging system operating under the provisions of this section must be below 10.6 GHz.
(b) Operation under the provisions of this section is limited to GPRs and wall imaging systems operated for purposes associated with law enforcement, fire fighting, emergency rescue, scientific research, commercial mining, or construction.
(1) Parties operating this equipment must be eligible for licensing under the provisions of part 90 of this chapter.
(2) The operation of imaging systems under this section requires coordination, as detailed in § 15.525.
(c) A GPR that is designed to be operated while being hand held and a wall imaging system shall contain a manually operated switch that causes the transmitter to cease operation within 10 seconds of being released by the operator. In lieu of a switch located on the imaging system, it is permissible to operate an imaging system by remote control provided the imaging system ceases transmission within 10 seconds of the remote switch being released by the operator.
(d) The radiated emissions at or below 960 MHz from a device operating under the provisions of this section shall not exceed the emission levels in § 15.209. The radiated emissions above 960 MHz from a device operating under the provisions of this section shall not exceed the following average limits when measured using a resolution bandwidth of 1 MHz:
| Frequency in MHz | EIRP in dBm |
|---|---|
| 960-1610 | -65.3 |
| 1610-1990 | -53.3 |
| 1990-3100 | -51.3 |
| 3100-10600 | -41.3 |
| Above 10600 | -51.3 |
(e) In addition to the radiated emission limits specified in the table in paragraph (d) of this section, UWB transmitters operating under the provisions of this section shall not exceed the following average limits when measured using a resolution bandwidth of no less than 1 kHz:
| Frequency in MHz | EIRP in dBm |
|---|---|
| 1164-1240 | -75.3 |
| 1559-1610 | -75.3 |
(f) For UWB devices where the frequency at which the highest radiated emission occurs, f
Syfert holds no separate history line for this section. Where this code prints a source or history note, it appears with the text, usually at the end.
Edition shown: eCFR text as of Sept. 29, 2026. Syfert holds no earlier or later version of this section.