Already have an account? Sign in instead.
You stay signed in for 30 days on this browser.
Continue with Google Continue with MicrosoftNo account yet? Create a free one.
We sent a six-digit code.
It expires in ten minutes, works once, and only in this browser. Five wrong tries void it. Send another code.
Your account is live and the Cloudflare checks are off for this browser.
Forward end structures of power car cabs
This section contains requirements for the forward end structure of the cab of a power car. (A conceptual implementation of this end structure is provided in Figure 1 to this subpart.)
(a) Center collision post. The forward end structure shall have a full-height center collision post, or its structural equivalent, capable of withstanding the following:
(1) A shear load of 500,000 pounds at its joint with the underframe without exceeding the ultimate strength of the joint;
(2) A shear load of 150,000 pounds at its joint with the roof without exceeding the ultimate strength of the joint; and
(3) A horizontal, longitudinal force of 300,000 pounds, applied at a point on level with the bottom of the windshield, without exceeding its ultimate strength.
(b) Side collision posts. The forward end structure shall have two side collision posts, or their structural equivalent, located at approximately the one-third points laterally, each capable of withstanding the following:
(1) A shear load of 500,000 pounds at its joint with the underframe without exceeding the ultimate strength of the joint; and
(2) A horizontal, longitudinal force of 300,000 pounds, applied at a point on level with the bottom of the windshield, without exceeding its ultimate strength.
(c) Corner posts. The forward end structure shall have two full-height corner posts, or their structural equivalent, each capable of withstanding the following:
(1) A horizontal, longitudinal or lateral shear load of 300,000 pounds at its joint with the underframe, without exceeding the ultimate strength of the joint;
(2) A horizontal, lateral force of 100,000 pounds applied at a point 30 inches up from the underframe attachment, without exceeding the yield or the critical buckling stress; and
(3) A horizontal, longitudinal or lateral shear load of 80,000 pounds at its joint with the roof, without exceeding the ultimate strength of the joint.
(d) Skin. The skin covering the forward-facing end of each power car shall be:
(1) Equivalent to a
(2) Securely attached to the end structure; and
(3) Sealed to prevent the entry of fluids into the occupied cab area of the equipment. As used in paragraph (d), the term “skin” does not include forward-facing windows and doors.
Syfert holds no separate history line for this section. Where this code prints a source or history note, it appears with the text, usually at the end.
Edition shown: eCFR text as of Sept. 29, 2026. Syfert holds no earlier or later version of this section.