15 U.S.C. § 8005
Minimum State law requirements
Nothing in this section prevents the Commission from promulgating standards regulating pool and spa safety or from relying on an applicable national performance standard.
A safety pool cover.
A gate with direct access to the swimming pool or spa that is equipped with a self-closing, self-latching device.
Any door with direct access to the swimming pool or spa that is equipped with an audible alert device or alarm which sounds when the door is opened.
A device designed to provide rapid detection of an entry into the water of a swimming pool or spa.
A safety vacuum release system which ceases operation of the pump, reverses the circulation flow, or otherwise provides a vacuum release at a suction outlet when a blockage is detected, that has been tested by an independent third party and found to conform to ASME/ANSI standard A112.19.17 or ASTM standard F2387, or any successor standard.
A suction-limiting vent system with a tamper-resistant atmospheric opening.
A gravity drainage system that utilizes a collector tank.
An automatic pump shut-off system.
A device or system that disables the drain.
Any other system determined by the Commission to be equally effective as, or better than, the systems described in subparagraphs (A) through (E) of this paragraph at preventing or eliminating the risk of injury or death associated with pool drainage systems.
Any device or system described in subparagraphs (B) through (E) of paragraph (1) shall meet the requirements of any ASME/ANSI or ASTM performance standard if there is such a standard for such a device or system, or any applicable consumer product safety standard.
In this section, the term “State” includes an Indian Tribe.
2022—Subsec. (a)(2). Pub. L. 117–328, § 402(b)(1), substituted “the eligibility of a covered entity” for “the eligibility of a State” in subpars. (A) and (B).
Subsec. (e). Pub. L. 117–328, § 402(b)(2), added subsec. (e).
2014—Subsec. (a)(1)(A). Pub. L. 113–76, § 501(2)(A), inserted “and” at end of cl. (i), redesignated cl. (iii) as (ii) and inserted “and” at end, and struck out former cl. (ii) and cls. (iv) and (v) which read as follows:
“(ii) that all pools and spas be equipped with devices and systems designed to prevent entrapment by pool or spa drains;
“(iv) every swimming pool and spa that has a main drain, other than an unblockable drain, be equipped with a drain cover that meets the consumer product safety standard established by section 8003 of this title; and
“(v) that periodic notification is provided to owners of residential swimming pools or spas about compliance with the entrapment protection standards of the ASME/ANSI A112.19.8 performance standard, or any successor standard; and”.
Subsec. (a)(2) to (4). Pub. L. 113–76, § 501(2)(B), (C), redesignated pars. (3) and (4) as (2) and (3), respectively, substituted “paragraph (1)(B)” for “paragraph (1)” in introductory provisions of par. (3), and struck out former par. (2) which read as follows: “The minimum State law notification requirement under paragraph (1)(A)(v) shall not be construed to imply any liability on the part of a State related to that requirement.”
Section effective on the date that is 1 day after